Aokin 3D Printer Bed Springs 8mm OD 20mm Compression Die Springs for Ender 3, 10 Pcs Review (2026)

What this product actually is

This is a set of 10 yellow spring steel compression springs sized at 8mm outer diameter and 20mm free length, built as a direct swap for the stock bed leveling springs found on the Ender 3, Ender 3 Pro, Ender 3 V2, and Ender 3S. The listing describes them as a light load design rather than a heavy duty or stiffened die spring, which means they are meant to match the feel of the original hardware rather than change how firm the bed leveling knobs feel to turn. Their main job is replacing old, fatigued stock springs that have lost even tension after months or years of compression and release.

Why worn stock springs cause problems

Bed leveling springs on printers like these compress every time the bed knob is tightened and hold that tension between prints. Over enough cycles, factory springs can lose some of their original stiffness unevenly across the four corners, which shows up as a bed that seems to drift out of level between prints even though nothing was physically bumped or adjusted. Fresh springs with even, consistent tension across all four corners address that specific symptom, since matched new springs compress and hold tension the same way at every corner, removing one variable from an otherwise confusing leveling drift.

Fit and installation

At 8mm outer diameter and 20mm length, these springs are sized to match the stock spring cavity on Ender 3 family printers without any modification, sliding onto the same leveling screws beneath the print bed. Installation is the same as replacing stock springs on any of these printers: loosen the bed knobs, lift the bed slightly, swap the old springs for new ones, and relevel as usual. Since the springs match the stock design rather than a stiffer aftermarket profile, no change to leveling technique or knob turning force should be expected after the swap, which makes this a low risk, drop in maintenance part rather than an upgrade requiring retuning.

What this is not

Buyers expecting these to feel noticeably stiffer or firmer than worn stock springs, or to fundamentally change how the bed resists movement over time, may be disappointed, since the springs are described as light load rather than as reinforced die springs built for heavier resistance. Anyone specifically looking for a stiffer spring upgrade to reduce bed sag under a heavier glass or magnetic bed plate should look for springs explicitly marketed as heavy duty or die springs with a higher spring rate, since this product is positioned as a like for like replacement rather than a stiffness upgrade. Treat it as routine maintenance hardware, not as a performance modification to the bed leveling system itself.

Who should buy this set

This set fits anyone whose Ender 3 family printer bed will not hold level between prints and whose existing springs have simply worn out from age and use, which is one of the more common and cheap fixes for that symptom before assuming a more serious mechanical issue. Ten springs cover one printer's full set with spares left over for a second machine or a future replacement. It is a poor fit for anyone specifically chasing a firmer, stiffer bed feel, since the light load design here is meant to restore original performance rather than exceed it.

Frequently asked questions